142
S. N. Mahottamananda et al.
Fig. 2 Schematic of experimental setup for cold flow test
the mass flow, respectively. A pressure gauge (Baumer Technologies) with a range of
0–8 bar is fitted at the injector reservoir chamber to measure the injection pressure.
Calibration of pressure regulators also been carried out.
2.3 Test Procedure
Figure 3 shows a schematic of the experimental setup. Swirl injector is fixed with
6.35 mm pipe vertically. The piston pump is switched on. Water gets pumped from
tank to swirl injector. Pressure regulator supplies a set pressure flow and the corresponding mass flow is noted through the rotameter. The spray patterns are obtained
Fig. 3 A schematic of the experimental setup with diffused backlight system
S. N. Mahottamananda et al.
Fig. 2 Schematic of experimental setup for cold flow test
the mass flow, respectively. A pressure gauge (Baumer Technologies) with a range of
0–8 bar is fitted at the injector reservoir chamber to measure the injection pressure.
Calibration of pressure regulators also been carried out.
2.3 Test Procedure
Figure 3 shows a schematic of the experimental setup. Swirl injector is fixed with
6.35 mm pipe vertically. The piston pump is switched on. Water gets pumped from
tank to swirl injector. Pressure regulator supplies a set pressure flow and the corresponding mass flow is noted through the rotameter. The spray patterns are obtained
Fig. 3 A schematic of the experimental setup with diffused backlight system